27 Clean up

Clean up your equipment.

1. remove all of the components from the breadboard
2. neatly replace all of the wires, resistors, and LEDs back in the small clear plastic case; close the case making sure that case snaps securely shut
3. disconnect and neatly coil the jumper wires with alligator clips
4. disconnect and neatly coil the USB cable from the Phidget
5. turn off the multimeter and neatly coil the probe wires
6. return the breadboard, Phidget, multimeter, electronic parts, jumper wires, and USB cable to the toolbox

Return the toolbox to the lab monitors and retrieve your photo ID.

Log out of the workstation before leaving (DO NOT turn the workstation off; the log out is under the menu in the upper right corner of the screen in the Default User submenu)