20 Clean up

Clean up your equipment.

  • remove all of the components from the breadboard
  • neatly replace all of the wires, resistors, and LEDs back in the small clear plastic case; close the case making sure that case snaps securely shut
  • disconnect and neatly coil the jumper wires with alligator clips
  • disconnect and neatly coil the USB cable from the Phidget
  • turn off the multimeter and neatly coil the probe wires
  • return the breadboard, Phidget, multimeter, electronic parts, jumper wires, USB cable, and USB adapter to the toolbox
  • return the toolbox and the webcam to the lab monitors and retrieve your photo ID.

Log out of the workstation before leaving (DO NOT turn the workstation off; the log out is under the menu in the upper right corner of the screen in the Default User submenu)