.. output_log

.. code-block:: none

    ...
    esptool.py --chip esp32c5 -p /dev/ttyUSB0 -b 460800 --before=default_reset --after=hard_reset --no-stub write_flash --flash_mode dio --flash_freq 80m --flash_size 2MB 0x2000 bootloader/bootloader.bin 0x10000 hello_world.bin 0x8000 partition_table/partition-table.bin
    esptool.py v4.9.dev6
    Serial port /dev/ttyUSB0
    Connecting....
    Chip is ESP32-C5 (revision v1.0)
    Features: WiFi 6, BT 5, IEEE802.15.4
    Crystal is 48MHz
    MAC: 30:ed:a0:ff:fe:e0:af:38
    BASE MAC: 30:ed:a0:e0:af:38
    MAC_EXT: ff:fe
    ROM expects crystal freq: 48 MHz, detected 48 MHz
    Changing baud rate to 460800
    Changed.
    Enabling default SPI flash mode...
    Configuring flash size...
    Flash will be erased from 0x00002000 to 0x00007fff...
    Flash will be erased from 0x00010000 to 0x00034fff...
    Flash will be erased from 0x00008000 to 0x00008fff...
    Erasing flash...
    Took 0.09s to erase flash block
    Writing at 0x00007400... (100 %)
    Wrote 22528 bytes at 0x00002000 in 0.7 seconds (276.3 kbit/s)...
    Hash of data verified.
    Erasing flash...
    Took 0.37s to erase flash block
    Writing at 0x00034c00... (100 %)
    Wrote 151552 bytes at 0x00010000 in 4.4 seconds (275.6 kbit/s)...
    Hash of data verified.
    Erasing flash...
    Took 0.02s to erase flash block
    Writing at 0x00008800... (100 %)
    Wrote 3072 bytes at 0x00008000 in 0.1 seconds (281.8 kbit/s)...
    Hash of data verified.

    Leaving...
    Hard resetting via RTS pin...